SDS

802042 OLYMPIC ELITE SEMI-TRANSPARENT/SEMI-SOLID SOLVENT BASED
EXTERIOR STAIN AMERICAN CHESTNUT
Product name
2
Product code
Date of issue
Version
00434220
19 November 2019
Section 6. Accidental release measures
Environmental precautions
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
:
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Large spill
:
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
Section 7. Handling and storage
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems or asthma, allergies or chronic or recurrent
respiratory disease should not be employed in any process in which this product is used.
Avoid exposure - obtain special instructions before use. Avoid exposure during
pregnancy. Do not handle until all safety precautions have been read and understood.
Do not get in eyes or on skin or clothing. Do not breathe vapor or mist. Do not swallow.
Use only with adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Do not enter storage areas and confined spaces unless adequately
ventilated. Keep in the original container or an approved alternative made from a
compatible material, kept tightly closed when not in use. Store and use away from heat,
sparks, open flame or any other ignition source. Use explosion-proof electrical
(ventilating, lighting and material handling) equipment. Use only non-sparking tools.
Take precautionary measures against electrostatic discharges. Empty containers retain
product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Special precautions
:
Ingestion of product or cured coating may be harmful. Vapors may accumulate in low or
confined areas or travel a considerable distance to a source of ignition and flash back.
Vapors are heavier than air and may spread along floors. Materials such as cleaning
rags, paper wipes and protective clothing, which are contaminated with the product may
spontaneously self-ignite some hours later. To avoid the risks of fires, all contaminated
materials should be stored in purpose-built containers or in metal containers with tight-
fitting, self-closing lids. Contaminated materials should be removed from the workplace
at the end of each working day and be stored outside. If this material is part of a
multiple component system, read the Safety Data Sheet(s) for the other component or
components before blending as the resulting mixture may have the hazards of all of its
parts.
United States
Page: 6/18