Use and Care Manual

802002 OLYMPIC ELITE SEMI-TRANSPARENT/SEMI-SOLID SOLVENT BASED
EXTERIOR STAIN ATLAS CEDAR
Product name
9
Product code
Date of issue
Version
00434218
28 June 2022
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store above the following temperature: 50°C (122°F). Store in accordance with
local regulations. Store in a segregated and approved area. Store in original container
protected from direct sunlight in a dry, cool and well-ventilated area, away from
incompatible materials (see Section 10) and food and drink. Store locked up. Eliminate
all ignition sources. Separate from oxidizing materials. Keep container tightly closed
and sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems or asthma, allergies or chronic or recurrent
respiratory disease should not be employed in any process in which this product is used.
Avoid exposure - obtain special instructions before use. Avoid exposure during
pregnancy. Do not handle until all safety precautions have been read and understood.
Do not get in eyes or on skin or clothing. Do not breathe vapor or mist. Do not swallow.
Use only with adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Do not enter storage areas and confined spaces unless adequately
ventilated. Keep in the original container or an approved alternative made from a
compatible material, kept tightly closed when not in use. Store and use away from heat,
sparks, open flame or any other ignition source. Use explosion-proof electrical
(ventilating, lighting and material handling) equipment. Use only non-sparking tools.
Take precautionary measures against electrostatic discharges. Empty containers retain
product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Special precautions
:
Ingestion of product or cured coating may be harmful. Vapors may accumulate in low or
confined areas or travel a considerable distance to a source of ignition and flash back.
Vapors are heavier than air and may spread along floors. Materials such as cleaning
rags, paper wipes and protective clothing, which are contaminated with the product may
spontaneously self-ignite some hours later. To avoid the risks of fires, all contaminated
materials should be stored in purpose-built containers or in metal containers with tight-
fitting, self-closing lids. Contaminated materials should be removed from the workplace
at the end of each working day and be stored outside. If this material is part of a
multiple component system, read the Safety Data Sheet(s) for the other component or
components before blending as the resulting mixture may have the hazards of all of its
parts.
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
United States
Page: 6/17