Manual

RFA Owner’s Manual Olympic Arms, Inc. • Tel (360) 456 - 3471

Installing The RFA Bolt Group Installing The Magazine Insert

Step 1

Step 2

Step 3

Step 4

The RFA bolt group assembly is designed to ﬁ t in a standard mil-spec AR upper

receiver in place of the bolt group assembly that came with your upper receiver.

Follow the steps below to properly install the RFA bolt group assembly:

• Clear the riﬂ e (see “Clearing The Riﬂ e” on previous page).

• Open the riﬂ e by pushing out the rear takedown pin and pivoting the receivers.

• Pull out the current bolt group assembly (see “Step 1” below).

• Insert the RFA bolt group assembly (see “Step 2” below).

• Pull the charging handle out about half way.

• Align the RFA bolt group assembly so that the guide rod and spring are directly

underneath the charging handle (see “Step 3” below).

• Push the RFA bolt group assembly the rest of the way into the upper receiver.

• Push the charging handle the rest of the way into the upper receiver.

• Check that the RFA bolt group assembly is ﬂ ush with the rear of the receiver

(see “Step 4” below).

• Pivot the riﬂ e to the closed position and lock the rear takedown pin shut.

Step 1

Step 2

Step 3

Step 4

The magazine adapter

insert is designed to install

into a standard AR (20) or

(30) round magazine.

Position and depress the

magazine adapter insert

into the magazine (see

photos 1 & 2). Next, tilt

the magazine adapter insert

on angle. Hook the head of

the magazine adapter insert

under the magazine lips of the outer magazine (see photo 3). Finally slide the

magazine adapter insert all of the way into the outer magazine (see photo 4).

For safety, it is recommended that the magazine adapter insert be installed into

the outer magazine before it is loaded with ammunition. The magazine adapter

insert has a maximum capacity of 10 rounds and is loaded in a standard fashion.

Insert one round at a time. Each round should be loaded rim ﬁ rst.