Manual

Bolt Carrier Disassembly
NOTE: The following illustrations
show the link pin removed from
the bolt carrier key. If you are dis-
assembling an OA-93/OA-96
Model 1, the link pin must be
removed. It is not necessary to
remove it on the OA-93/OA-96
Model 2, or the OA-93 Carbine.
The only time you must
remove
the link pin on these models is
when you wish to remove the bolt
carrier key from the bolt carrier.
To remove the link pin: use a
propane torch to apply heat to the
base of the link pin (1) to soften
the Red Loctite
used in assembly.
Use a standard
screwdriver to
unscrew link pin from bolt carrier
key. BE CAREFUL NOT TO BURN
YOURSELF ON THE HOT LINK
PIN
- use a pair of heavy gloves
for this step.
2. Move bolt assembly (6) forward
to unlocked position and
remove firing pin retaining pin
(7). Do not open or close split
end of firing pin retaining pin
(7).
3.
Push in on bolt assembly (6) to
put in locked position.
4. Catch firing pin (8) as it drops
out of rear of bolt carrier assem-
bly
(9).
cedures
\
0
6
20