Manual

Maintenance
OA-93/OA-96 Model 1
Continued from page 14
1. Using a hex wrench,
2. Using a large standard screwdriver,
remove front knurled locking nut
(2), and
push out front locking pin (3). Note that for-
ward pin is radiused on the side facing up, while
the rear pin is not.
3. Slide off scope mount base (4).
4. Using a propane torch, app
heat to the linking pin (4) to
soften the Red Loctite® used in
assembly, then unscrew the
link
pin from the bolt carrier
key
(5).
16