Operation Manual

Operation
www.olympia-vertrieb.de
OPERATING
INSTRUCTIONS
25Page
FM Radio
After the antenna has been plugged in the ANTENNA socket and the
equipment has been setup in the reception range for FM radio stations, it
can play them.
Automatic radio station scanning
1. Select the icon in the Radio menu
option and confirm the selection.
2. Press the [PRE−SCAN] button on the
remote control. The automatic radio station
pre−scanning function is started.
Alternatively, press and hold the [OK]
button directly on the unit until “Pre−Scan”
appears in the display. Then release the
[OK] button.
3. The stations found are automatically
saved. The bottom line indicates which
memory locations are assigned.
4. To select a radio station which has been
stored, enter the corresponding memory
location number (1 to 0) using the remote
control or use the  and  buttons.
Manual radio station scanning
1. Press the  button to increment the
frequency by 0.05 MHz at a time. Press
the  button to decrement the
frequency by 0.05 MHz at a time.
Set the required frequency.
2. Press the [Mem] button to save the
setting. “Ch 1” flashes in the display.
3. Press the  or  button to select
the required memory location (Ch 1 to
Ch 10) and confirm the selection.
Note: If the memory location is already assigned, a corresponding message
appears in the display. Confirm overwriting or cancel the process.
1&
()
87.50 MHz
Pre−Scan
()
108.00 MHz
Pre−Scanning...
()
96.50 MHz
Ch 2
()
96.55 MHz
()
96.60 MHz
Ch 1
()
96.60 MHz
()
96.60 MHz
Ch 2