Operating instructions
21
5.4 Shredding CDs, DVDs or credit cards
Note: Only insert 1 CD, DVD or credit card at a time for the shredding process.
1. The device is switched on and the ECS function is activated.
2. Insert the CD, DVD or credit card in the CD infeed.
Note: If, for security reasons, you want to shred credit cards using particle-cut
(cross-cut), you can also feed credit cards into the shredder’s paper infeed.
This only applies for credit cards and not for CDs/DVDs!
5.5 Emergency stop
If the ECS function is activated or forward or reverse operation are on, you can stop the
device in an emergency situation by pressing the ECS button.
5.6 Switching the device off
Set the On/Off switch to its OFF position.
6 Indicator Elements
Indicator Cause Solution
Device is ON
Overloading
(material jam)
Clear the material jam, refer to Chapter
“Clearing a material jam”. Observe the
recommended capacities regarding the
material to be shred stipulated in Chapter
“Technical Data”.
Motor has
overheated
Let the motor cool down, refer to Chapter
“Motor Protection”. Observe the operating
cycle described in Chapter “Technical Data”.
Waste bin full
The waste bin is full and must be emptied,
refer to Chapter “Emptying the waste bin”.
7 Motor Protection
The motor switches off automatically in the event of an overload. The red “motor
overheated” lamp lights up in this case.
1. First of all, disconnect the power plug from the power socket and allow the motor to
cool down to room temperature.
2. Then connect the power plug to the power socket again and continue operation.
Note: Observe the operating cycle stipulated in Chapter “Technical Data”.