Operation Manual

Operating Instructions
Page 7 of 18Homeplug Olympia 2000E Power
Connection and control lamps
The HomePlug 2000E Power is equipped with three control lamps, an Ethernet
connection port and a Simple Connect button.
Fig. 2 Connection and control lamps
Label LED lamp Description / Function
A The Simple Connect button serves to
produce a HomePlug network without
the need to use the software.
Refer to the Easy Start Guide leaflet.
B On/Off The power supply is available / not
available.
Flashing lamp The LED flashes for approx. 2
minutes (Registration mode) after
pressing the Simple Connect button.
C On/Off Another HomePlug device has been /
not been detected.
Red = up to 40 Mbps
Yellow = between 40 and 105 Mbps
Green = over 105 Mbps
D On/Off The Ethernet connection is
established / not established.
Flashing lamp The LED flashes when transmitting or
receiving data.
E RJ45 port
(underside)
Supports the use of both cross or
straight network cable.
F Reset button
(underside)
Press for 2 seconds to reset the
default settings.