Installation & Assembly

INSTALLATION
Tools:
Adjustable Wrench Plumbers Putty Sealant Tape Rags
Model Number: L-7570, L-7572 (CP, PVD BN,
ORB)
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
OLYMPIA FAUCETS, INC.
Interchange City Distribution Center #20
1277 Heil Quaker Boulevard
La Vergne, TN 37086
[phone]
www.olympiafaucets.com
Installation Steps:
Two Handle Lavatory Faucet
(1) Shut off water supplies. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
(2) Place the faucet in position on the sink.
Apply plumbers putty under the base gasket.
Install washer on shanks and tighten with
locknut from under the sink
(3a) When using ball-nose exible supplies to
connect faucet to water supplylines, slip cou-
pling nut onto exible supply. Ball-nose cou-
pling will go partially into IPS shank. Tighten
coupling nut (DO NOT OVER TIGHTEN). In-
stall opposite end according to manufacturer’s
instructions for both tubes..
(3b) When using stainless steel braided
faucet supply hose, this faucet requires one
end of the supply hose to have a 1/2” female
IPS connection. The other end of this supply
hose must match the thread on the water
supply valve under your sink. Once you’ve
identied the required size, carefully follow
the manufacturer’s installation instructions for
each hose.
(4) Turn on water supplies. Check for any
minor joint leaks. Remove aerator from spout
by turning counterclockwise. Turn on both side
handles. Flush and allow water to run at full
ow at least one minute. Turn off both side
handles. Replace aerator.
(1) Remove pop-up ange from body
(2) Place a ring of putty on the bottom of
ange.
(3) Insert pop-up ange through drain
hole and attach ange to body. Ensure
the pop-up outlet faces towards the sink.
Do not overtighten.
Pop-up Drain Installation:
(4) Remove the excess putty. Connect the
trap (check manufacturer’s instructions for
installation).
(5) Remove rod nut. Insert rod. Tighten
the rod nut.