User manual

OLIMEX© 2012 SHIELD-EKG-EMG
SECTION 7 REVISION HISTORY
7.1 Document revision
Revision Changes
Modified
Pages
A Initial Creation All
B
Added important note on removing a wire at R6 pads
from OLIMEXINO-328
11.12
C
Fixed error on page 7 about the LED color
Added note on page 12 about possible damage due to
lack of experience
Changed schematic with a searchable one
Various formatting adjustments
7, 12, 16
D
Changed disclaimer section to represent the open-
source nature of the shield
Added explanation of the cable
2, 15
E
Changed formatting of the document
Updated links
All
7.2 Web page of your device
The web page you can visit for more info on your device is
https://www.olimex.com/Products/Duino/Shields/SHIELD-EKG-EMG/.
There are examples and libraries available for Arduino IDE, Pinguino IDE and Maple IDE.
7.3 Ordering info
ORDER CODES:
SHIELD-EKG-EMG - completely assembled and tested
OLIMEXINO-328 – Arduino based board with ATmega328, fully compatible with SHIELD-
EKG-EMG
How to order?
You can order directly from our online shop or from any of our distributors. The list of
distributors might be found here: https://www.olimex.com/Distributors.
Check our web page https://www.olimex.com/ for more info.
Page 20 of 20