User manual

• Internal 8 MHz and 32 kHz oscillators

• Separate PLLs for CPU and USB clocks

• Two I2C™ modules

• Two UART modules with:

- RS-232, RS-485 and LIN support

- IrDA® with on-chip hardware encoder and decoder

• Up to two SPI modules

• Parallel Master and Slave Port (PMP/PSP) with 8-bit and 16-bit data and up to 16 address

lines

• Hardware Real-Time Clock and Calendar (RTCC)

• Five 16-bit Timers/Counters (two 16-bit pairs combine to create two 32-bit timers)

• Five capture inputs

• Five compare/PWM outputs

• Five external interrupt pins

• High-Speed I/O pins capable of toggling at up to 80 MHz

• High-current sink/source (18 mA/18 mA) on all I/O pins

• Configurable open-drain output on digital I/O pins

Debug Features:

• Two programming and debugging Interfaces:

- 2-wire interface with unintrusive access and real-time data exchange with

application

- 4-wire MIPS® standard enhanced JTAG interface

• Unintrusive hardware-based instruction trace

• IEEE Standard 1149.2-compatible (JTAG) boundary scan

Analog Features:

• Up to 16-channel 10-bit Analog-to-Digital Converter:

- 1000 ksps conversion rate

- Conversion available during Sleep, Idle

• Two Analog Comparators

For comprehensive information on the microcontroller visit the Microchip's web page for a

datasheet.

At the moment of writing the microcontroller datasheet can be found at the following link:

http://ww1.microchip.com/downloads/en/DeviceDoc/61143H.pdf

Page 14 of 29