User manual

3) Uploading the hex via Internet BL – go to Start Menu → Run → cmd.exe. Prepare to trigger the
uploading by entering the command line. The format is:
tftp <IP> put <hex file>
Now reset the board, within next 4 seconds (while BL is active) trigger the command in console and
wait few seconds until uploading is complete. If everything is fine you should get message like this:
From now on when you reset the board within the first 4 seconds the BL will be active (in case you
want to update the firmware) and ofter that the hex you upload.
Page 29 of 36