User manual

To toggle the status LED of the board (PIC-WEB) you can click on the green dot under the caption
“LEDs:”. By clicking on this dot you are changing the state of the pin, see how the led switch on or switch off.
From the I2C Demo menu you can send command via UEXT to a MOD connected to the extension.
At the page you can also see some values of the PIC-WEB sensors and buttons:
• Buttons:
• Potentiometer:
• Temperature:
• Reset
“Potentiometer” shows a measurement from the PIC A/D connected to a 10KΩ potentiometer on the
board, you can freely change that potentiometer position and check how the measurement changes.
“Temperature” shows the value of the temperature sensed by the thermistor in the board connected to
another A/D port of the PIC18F67J60.
“Buttons” shows the state of the on-board button. It is “^” while the button is not pressed and “V” if it is
pressed.
"Reset" - The reset button allows you to reboot the board from distance. You can use this option in
order to upload new firmware for example.
From the UART/I2C/SPI Demo menus you can send command via UEXT to any of these three interfaces MOD
devices connected to the extension.
Page 21 of 36