User manual

This configuration will let you test the board directly from your PC but isn’t too useful. The fun stuff
begins when you have the PIC-WEB connected to internet. Just imagine your sensor monitor project, but now
you will be able to see the information anywhere just browsing the address of the board!
Test WEB page:
As it was mentioned above, the PIC-WEB board has an embedded web server and a demo page. The
page shows some of the features of the board and like peripherals and UEXT interfaces demo.
To access the demonstration page, the server must be accessible from the computer. The default IP
address of the board is 192.168.0.30, and 192.168.0.1 is the gateway. Those values must been set to work with
your net. In this manual we have set IP address of the board to 192.168.0.171 (from the DHCP). Then you can
get the page with any web browser writing the IP address of the board on the address bar.
At the picture below, you can see the default page that you must get. It shows the temperature of the on-
board thermistor, the status of the button BUT, the value of the potentiometer, the status of the LED, software
reset button and so on.
Page 19 of 36