User manual

POWER SUPPLY CIRCUIT:
OLIMEXINO-STM32 can take power supply from:
– external power supply (9-30) VDC.
– + 5V from USB
– 3.7 V Li-ion battery
The programmed board power consumption is about 50 mA with all peripherals
enabled.
RESET CIRCUIT:
OLIMEXINO-STM32 reset circuit includes D6 (1N4148), R28 (10kΩ), R29
(330Ω), C31 (100nF), STM32F103RBT6 pin 7 (NRST) and RESET button.
CLOCK CIRCUIT:
Quartz crystal Q1 8 MHz is connected to STM32F103RBT6 pin 5
(PD0/OSC_IN) and pin 6 (PD1/OSC_OUT).
Quartz crystal Q2 32.768 kHz is connected to STM32F103RBT6 pin 3
(PC14/OSC32_IN) and pin 4 (PC15/OSC32_OUT).
JUMPER DESCRIPTION:
Note that all jumpers on the board are SMD type. You will need to solder/unsoder/cut them
in order to reconfigure them.
LED1_E
This jumper, when is closed, enables LED1.
Default state is closed.
LED2_E
This jumper, when is closed, enables LED2.
Default state is closed.
D23_E
This jumper, when is closed, connects STM32F103RBT6 pin (PC15/OSC32_OUT) –
signal D23 to EXT pin 1, and when is opened, D23 is not connected to EXT.
Default state is opened.
R-T
This jumper, when is closed, connects TRST and RESET, and when is opened, TRST
and RESET are separated.
Page 7 of 19