User manual

6.2 Useful web links and purchase codes

The web page you can visit for more info on your device is

https://www.olimex.com/Products/AVR/Programmers/AVR-ISP-MK2/.

For more info on the original ISP-MK2 design please visit:

http://www.atmel.com/tools/AVRISPMKII.aspx.

You can get the latest updates on the software at: http://www.fourwalledcubicle.com/LUFA.php.

ORDER CODES:

AVR-ISP-MK2 – assembled and tested AVR-ISP compatible programmer

AVR-ICSP – 10 ↔ 6 pin ICSP adapter cable, since AVR-ISP-MK2 has only 10-pin ICSP interface

How to purchase Olimex products?

You can order from our web-shop or from any of our distributors. The list of official Olimex

distributors might be found at: https://www.olimex.com/Distributors/.

Please check https://www.olimex.com/ for more info.

6.3 FAQ

Q1: The programmer is not recognized in AVR studio! What should I do?

A1: The most common ways to resolve such an issue are:

1. Most of the problems that customers encounter with AVR-ISP-MK2 are related to the driver

installation. Make sure that you have installed the driver suitable for the current firmware of the

programmer (and note MAKE SURE THAT YOU HAVE UNINSTALLED THE ALTERNATIVE

DRIVER). Sometimes the Jungo driver behaves strange. Try to uninstall it completely from Control

panel –> Add/Remove programs (Programs and Features in Windows 7) – the driver is usually

named “AVR Jungo USB” or “Atmel USB”. Then install the latest “Atmel USB” driver.

2. When AVR-ISP-MK2 is connected to the USB, in Windows Device Manager you should see a

tab named “Jungo” or “Jungo Connectivity”. When you click to expand this tab you should see

“AVR-ISP mkII” and “WinDriver” devices and there SHOULD NOT be any warnings with

exclamation marks!!! If there is exclamation mark this probably means the driver is not enabled

because of the drivers are not signed in Windows 7, 8, and 10 (please seek more information for

how to disable driver signature enforcements). If the device is recognized as other tool you might

need to change the firmware with the Atmel compatible one (which is the default one).

Q2: I can connect to the programmer, but can't connect the programmer to the target. Also

when I try to read the device ID there are errors. What should I do?

A2: The most common ways to resolve such an issue are:

1. Check if you have used the proper interface according to your target.

Page 22 of 24