User manual

OLIMEX© 2015 AVR-ISP-MK2 user's manual
Special mention for Olimex boards – sometimes the board refuses to reset before programming
when using Arduino. Try holding the reset button and release it simultaneously while clicking
“Upload Using Programmer”.
4.2.4 10-pin ICSP to 6-pin ICSP cable
ICSP is the most common one but some boards have only 6-pin ICSP. In such a case you should
either get the low-cost adapter AVR-ICSP we manufacture or make a 10-pin to 6-pin adapter as
show below (or just use male-female jumper cables):
Page 16 of 24