Datasheet

had suggested to fix the bug by “AVR Studio 4.13 SP2 JTAGICE Fix”
available from http://www.atmel.no/beta_ware/
PROCESSOR FEATURES:
AVR-CAN board use MCU AT90CAN128 from Atmel with these features:
High-performance, Low-power AVR® 8-bit Microcontroller
Advanced RISC Architecture
- 133 Powerful Instructions – Most Single Clock Cycle Execution
- 32 x 8 General Purpose Working Registers + Peripheral Control
Registers
- Fully Static Operation
- Up to 16 MIPS Throughput at 16 MHz
- On-chip 2-cycle Multiplier
Non volatile Program and Data Memories
- 128K Bytes of In-System Reprogrammable Flash
o Endurance: 10,000 Write/Erase Cycles
- Optional Boot Code Section with Independent Lock Bits
o Selectable Boot Size: 1K Bytes, 2K Bytes, 4K Bytes or 8K Bytes
o In-System Programming by On-Chip Boot Program (CAN,
UART, ...)
o True Read-While-Write Operation
- 4K Bytes EEPROM (Endurance: 100,000 Write/Erase Cycles)
- 4K Bytes Internal SRAM (AT90CAN32/64/128)
- Up to 64K Bytes Optional External Memory Space
- Programming Lock for Software Security
JTAG (IEEE std. 1149.1 Compliant) Interface
- Boundary-scan Capabilities According to the JTAG Standard
- Programming Flash (Hardware ISP), EEPROM, Lock & Fuse Bits
- Extensive On-chip Debug Support
CAN Controller 2.0A & 2.0B - ISO 16845 Certified
- 15 Full Message Objects with Separate Identifier Tags and Masks
- Transmit, Receive, Automatic Reply and Frame Buffer Receive Modes
- 1Mbits/s Maximum Transfer Rate at 8 MHz
- Time stamping, TTC & Listening Mode (Spying or Autobaud)
Peripheral Features
- Programmable Watchdog Timer with On-chip Oscillator
- 8-bit Synchronous Timer/Counter-0
o 10-bit Prescaler
o External Event Counter
o Output Compare or 8-bit PWM Output
- 8-bit Asynchronous Timer/Counter-2
o 10-bit Prescaler
o External Event Counter
o Output Compare or 8-Bit PWM Output
o 32Khz Oscillator for RTC Operation
- Dual 16-bit Synchronous Timer/Counters-1 & 3
o 10-bit Prescaler
o Input Capture with Noise Canceler
o External Event Counter
o 3-Output Compare or 16-Bit PWM Output
Page 3