The SOYO CD Motherboard Quick Start Guide Quick BIOS Setup DRAGON 2 Intel USB2.
SOYO™ 1. Please read the users guide before proceeding with your installations. Serious damage may occur if the procedure is not followed properly. 2. This motherboard does not support CPUs with a Vcore higher than 1.6 volts. Please make sure the CPU you are using 1.6 volts or below. Check the CPU specification before you insert it in the CPU socket. 3. AGP cards running at 3.3v are not supported. Only AGP cards running at 1.5v (most 4x or 8x AGP cards) are supported on this mainboard. 4.
SOYO™ SY-P4I865PE Lite DRAGON 2 Motherboard mPGA Socket 478 processors Intel 865PE AGP/PCI Motherboard 400/533/800 MHz Front Side Bus supported ATX Form Factor Copyright © 2003 by SOYO Computer Inc. Trademarks: SOYO is a registered trademark of SOYO Computer Inc. All trademarks are properties of their owners. Product Rights: All names of the product and corporate mentioned in this publication are used for identification purposes only.
Introduction SY-P4I865PE Lite DRAGON 2 Quick Start Guide 1 Introduction Congratulations on your purchase of the SY-P4I865PE Lite DRAGON 2 Motherboard. This Quick Start Guide illustrates the steps for installing and setting up your new Motherboard. This guide provides all users with the basic steps of Motherboard setting and operation. For further information, please refer to the SY-P4I865PE Lite DRAGON 2 Motherboard User's Manual that came with your Motherboard.
SY-P4I865PE Lite DRAGON 2 Motherboard Layout DDR_A1 DDR_A2 DDR_B1 PS/2 KB PS/2 Mouse Connector Connector USB COM A COM B PRT +12V Power USBLAN ATX Power MIC IN / Center & Bass out Audio out / Front out Audio in / Rear out IDE 2 AGP Slot 5 2 1 IDE 1 FDC1 J30 6 DAVICOM DM9102AE PCI Slot #1 AC97 codec JP5 PCI Slot #2 1 4 1 AUX_IN1 4 CMOS Clear Jumper SATA2 PCI Slot #3 CDIN1 SATA1 PCI Slot #4 ITE IT8712F PCI Slot #5 13 14 1 2 SMCARD 5 1 SIRCON 15 16 GAMEPORT 1 2 6 1 10 4
Introduction SY-P4I865PE Lite DRAGON 2 Quick Start Guide Key Features CPU Chipset Memory AGP PCI Super I/O Supports Intel® mPGA Socket 478 processors : Pentium® 4 with and without Hyperthreading, Northwood, Prescott (400/533/800MHz FSB) Pentium® 4 Celeron SOYO COMBO Setup CMOS setup menu for complete and easy changing of your CPU settings in CMOS setup, making jumpers obsolete. Note: CPU with higher than 1.6 volts are not supported.
Storage USB 2.0 Sound Network BIOS Industry standards ICH5 integrated Serial ATA controller supporting up to 2x UDMA 150 hard disks ICH5 Integrated Parallel ATA controller supporting up to 4x UDMA 33/66/100 Parallel ATA devices. 8x USB 2.0 compliant ports (4 on rear IO panel, 4x motherboard connectors.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 2 Installation Hardware Installation To avoid damage to your Motherboard, please follow these simple rules while handling this equipment: Before handling the Motherboard, ground yourself by touching on to an unpainted portion of the system's metal chassis. Check the mainboard for damage. If any component appears to be loose or damaged contact our customer service center immediately.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Install the Motherboard We will now begin the installation process. Please follow the following procedure to lead you to a complete and correct installation. Step 2- Install memory modules Step 3- Connect cables, case wires, power supply and install expansion cards Step 4- Install expansion cards Step 1. Install the CPU CPU Mount Procedure: To mount the Pentium® 4 Socket mPGA478 processor that you have purchased separately, follow these instructions.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Hardware Installation Configure Memory This motherboard supports one Dual Channel to your memory. Note that you can use normal DDR memory for Dual Channel to work. Also note that for Dual Channel to work 2 modules of equal size and specifications have to be installed. The largest memory capacity possible is 3GB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Step 2. Connect cables, case wires, and power supply The internal peripherals consist of IDE devices (HDD, CD-ROM, etc), Floppy Disk Drive, Chassis Fan, Front Panel Devices (ACPI LED, Internal Speaker, Reset Button, IDE LED, and KeyLock Switch.), Wake-On-LAN network card, VGA card, Sound Card, and other devices.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Connectors and Plug-ins CPU Cooling Fan: CPUFAN1 Pin1 Pin2 Pin3 Chassis Fan: CHAFAN1 Pin1 Pin2 Pin3 GND GND +12V Sensor Hardware Installation Chassis Fan: CHAFAN2 +12V Sensor Standard IrDA (Infrared Device Header): SIRCON Pin1 Pin2 Pin3 Pin1 Pin2 Pin3 Pin4 Pin5 GND +12V NC VCC NC IRRX GND IRTX CD-IN Pin1 Pin2 Pin3 Pin4 Pin1 AUX_IN1 Pin2 Pin3 Left GND GND Right Left GND GND Pin4 Right MIC & LED Connector: J30 Pin1 Pin2 Pi
Power On/Off: PWRBT Connect your power switch to this header (momentary switch type). To turn off the system, press this switch and hold down for longer than 4 seconds. ATX 12V Power Supply: ATX PW Attach the ATX 12V Power cable to three connector. (This motherboard requires an ATX 12V power supply, an AT or ATX power supply can NOT be used.) When using the Power-On by Keyboard function, please make sure the ATX power supply is able to provide at least 720mA on the 5V Standby lead (5VSB).
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Please install the ATX power according to the following pin assignment: Hardware Installation ATX Power 12V 5VSB PW-OK GND 5V GND 5V GND 3.3V 3.3V Pay special care to the directionality. 5V 5V -5V GND GND GND PS-ON GND -12V 3.3V Pin1 Pin3 COM +12VDC +12V Power Connector FIG. 2 FIG. 1 Install expansion cards The motherboard has 1 AGP slot and 5 PCI slots. Step 3. 1.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide This motherboard only support 1.5V AGP card (4X/8X card). If 3.3V AGP card is used, the system will not boot-up and the AGPDET LED will lit. (1.5V only) (When AGPDETLED lit, it m ea ns 3.3V AGP c a rd is use d.) If use 3.3V AGP c a rd ,the syste m will no t p o we r o n a nd the AG PDET LED will lit. CMOS Clear (JP5) In some cases the CMOS memory may contain wrong data, follow the steps below to clear the CMOS memory. 1.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Audio Speakers connections When using 2-channel speaker, connect the speaker cable to line-out. If you’re using 4 channel speaker, connect the front L/R speakers to line-out and rear Hardware Installation L/R speakers to Line-in. make sure to set the Audio Rack software for 4 channel speaker system. Do not forget to set the Audio Rack software to 4-channel system.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Onboard LAN LED Definition When this LED is lit, this means the LAN is running at 100 mbps, if it is not lit, the Onboard LAN is working at 10 mbps. Hardware Installation This is the LAN activity & link LED. It will blink when it is active.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 3 Quick BIOS Setup This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO FEATURE]. The [SOYO COMBO FEATURE] combines the main parameters that you need to configure, all in one menu, for a quick setup in BIOS.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 4 The SOYO CD The SOYO-CD will Auto Run only in Windows Based Operating Systems. Your SY-P4I865PE Lite DRAGON 2 motherboard comes with a CD-ROM labeled “SOYO CD”. The SOYO CD contains a. The user’s manual for your new motherboard in PDF format, b. The driver software necessery for installation, and c. A database in HTML format with information on SOYO motherboards and other products. Step 1.
The SOYO CD SY-P4I865PE Lite DRAGON 2 Quick Start Guide The user's manual files included on the SOYO CD are in PDF (Postscript Document Format). In order to read a PDF file, the appropriate Acrobat Reader software must be installed in your system. Note: The Start Up program automatically detects if the Acrobat Reader utility is already present in your system, and otherwise prompts you on whether or not you want to install it.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide driver revision: Intel Chipset Software Installation Utility for Win 98SE/ME/2000/XP Intel USB2.0 Driver for Win 98SE/ME Intel USB2.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide to begin the driver installation program. When the installation is complete, most drivers require a restart of your system before they become active. Step 3. Check the Latest Releases Click the 'Connect to SOYO website' button to go the SOYO Website to find the latest BIOS, manual and driver releases for your motherboard. This button will only work if your computer is connected to the internet through a network or modem connection.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The SOYO CD After Windows XP installation, your device manager should look like this: 23
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The SOYO CD After driver installation, your Windows XP device manager should look like this: Note: To install the USB 2.0 driver, please update to Windows XP service pack 1.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The SOYO CD Drivers directory list in the CD driver 25
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 5 Intel USB2.0 Driver Installation For Windows XP USB 2.0 drivers are available for download using Windows Update for both Windows XP and Windows 2000. For additional information regarding USB 2.0 support in Windows XP and Windows 2000, please visit http://www.microsoft.com/hwdev/bus/USB/default.asp ( Windows XP Service Pack1 Include USB2.0 Driver ) After installing service pack1, please do the following: 1. Go into the device manager. 2. Remove “ 3.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Quick Trouble shoot tips Boot-up Issues The system does not power-up, no beeping sound heard and the CPU fan does not turn on. 1. 2. 3. 4. 5. Check if the power cord is plugged in the power source. Check if the power is connected to the M/B. (both the ATX 12V and the ATX connector) Check if the cable of the case power button is connected to the M/B power button connector (see connectors and plug-ins in this quick start guide for more info).
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The system turns on for some seconds then shutdown by itself. 1. 2. 3. 4. 5. Check if the CPU fan is connected to the CPUFAN1 connector. The CPU might be overheating. Check the CPU FAN if it is defective or see if the CPU fan is in contact with the CPU. Clear the CMOS ram. (JP5 connector, see this Quick start guide for more info on how to clear the CMOS). Make sure the power supply you have in your system supports the M/B specification. Example.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 5. 6. 7. 8. 9. the BIOS setup is set to Turbo/Maximum. Set it to normal if so. Check the website for latest BIOS update. Check the website for FAQ’s regarding instability issues. Change the memory module or CPU, they might be defective. The power supply might not have enough wattage to support all the peripherals. If your system has other peripherals connected, like CD-RW, extra HDD, etc. disconnect them. And see if the problem is gone then.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide After flashing the BIOS, my system will not boot-up. 1. 2. Try clearing the CMOS ram. The BIOS chip is defective due to an unsuccessful flash, contact your nearest SOYO branch for re-flashing. Is there a way to reprogram my BIOS after an unsuccessful flash? No other way, you need to send back the BIOS ROM to your nearest SOYO branch for re-flashing.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The sound is working in my system, but when I play CD music from the CD-ROM, I do not get any sound. What is wrong? This is because the 4-wire audio cable from the CD-ROM to the on-board CDIN1 connector on the M/B is not connected. See manual for location of CDIN1. The sound and everything else works fine except that the line-in and/or microphone doesn’t work. What is wrong? 1. 2.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide LAN Issues During LAN driver installation, the system hangs on 75%, why? Enable the onboard LAN in the BIOS setup. I have problem installing Novell NetWare v.50 Disable the APIC option in the BIOS. For updated FAQs, please check http://www.soyo.com.tw/faq.htm or http://www.soyousa.com/faqs.
SY-P4I865PE Lite DRAGON 2 Quick Start Guide How to contact us: If you are interested in our products, please contact the SOYO sales department in the region you live. If you require Technical Assistance, please contact our Technical Support in the region you live. SOYO prefers Email as communication medium, remember to always add to the email the country that you live in. TAIWAN Hong Kong SOYO COMPUTER INC. SOYO ASIA LTD. No. 21 Wu-Kung 5 Rd., Hsin Chuang City, Taipei Hsien, Taiwan, R.O.
Edition : April 2003 Version P1.
