Installation Guide

myolgoce.com
Uni Flip Table
TECHNICAL INSTAL
LATION
01
Page 3
Pencil mark the centre-line of table top underside. Locate frame in the centre of
worksurface and fully tighten using the M5x30 screws.
Hook the side-handle wires into the flip mechanism.
Fit the pullbar into the side-handles.
Place the drop-rail cross tube (45mm diameter) between the legs and fully tighten
the M8x80 bolts through the plugs into the drop-rail. Making sure the notch in the
end of the drop-rail cross tube is in-line with the bumps on the frames.
03
01 02
04