Installation Guide
Table Of Contents
INSTALLATION GUIDE
myolgoce.com
Modulus Single Post Collar Leg Table - Single Span
Page 3
01
03 04
02
Place a leg pole tube
3
on top of a collar. Align the notch. Fully tighten the M10x110
bolt
12
, spring washer and flat washer through the collars. Repeat for both leg
assemblies.
* The top of the leg tube has more rim
notches than the bottom of the leg tube.
Slide 2 large feet
4
into the collar, place the 150° gasket
9
on top and fully tighten the
2 M8x16mm bolts
13
into the collar
7
. (Repeat with all collars).
Place the upper wrist
1
on top of the leg tube, making sure each small notch in the
top of the leg tube is in-line with the bumps on the bottom of the upper wrist.
Fully tighten to maximum tension the M10x30mm bolts
11
. Repeat for both leg
assemblies.
Screw all glides
5
into the base of the large feet, leaving the glides one turn from
tight (then they can be adjusted easily if the floor is uneven).
12
11
1
3
13
9
4
5
7