Installation Guide

INSTALLATION GUIDE
myolgoffice.com
Modulus Single Post Pedestal Table
01
03 04
02
Place the feet tube into the cross collar, making sure the notch in the bottom of the
tube is in-line with the bump inside the cross collar Fig A. Fully tighten the large M10
bolt, spring washer and flat washer through the gasket and collar into the tube.
Slide the 4 large feet into the cross collar. Place the cross gasket on top of the feet
and collar, and tighten 4xM5 screws into the cross collar.
Locate the steel plate on top of the feet tube, and line up the 3 holes. Fully tighten
the 3 screws into the tube.
Screw the 4 glides into the base of the large feet, leaving the glides one turn from
tight (then they can be adjusted easily if the floor is uneven).
Fig A