Installation Guide

INSTALLATION GUIDE
myolgoffice.com
Modulus 4 Post Pedestal Table
05
07 08
06
Carefully place the assembled frame upside down on top of the work surface.
Measure the distance from the upper wrist to the edge of the work surface, and
make sure the frame is centered over the work surface.
Place each upper wrist on top of the feet tubes. Place the top rail caps into the
large holes. Fully tighten to maximum tension M10x30mm bolts to hold the upper
wrist in place.
Screw the M5x20mm self tapping screws into the work surface, located on the
upper wrist and steel straps.
Place the 2 steel straps onto the upper wrists, with the raised areas of the straps
slotting into the holes on the upper wrist, Fig D. Fully tighten to maximum tension
the M6x25mm bolts, locking the upper frame into place.
Fig D