Installation Guide

INSTALLATION GUIDE
myolgoffice.com
Modulus 4 Post Pedestal Table
01
03 04
02
With all 4 feet assembled, connect them to the T tube and cross connector using
M8x16mm bolts.
Slide the large foot, T connector and 2 cross collar plugs into the cross collar,
place the minus gasket on top, and fully tighten the 2 bolts into the collar. (Repeat
with all 4 legs)
Place the 4 feet tubes onto the cross collars. Fully tighten to maximum tension
M10x110mm bolts, spring washer and flat washer, that hold the feet tube onto the
cross collar. (Repeat with all 4 tubes)
Screw the 4 glides into the base of the large feet, leaving the glides one turn from
tight (then they can be adjusted easily if the floor is uneven).