User's Manual

BALANCE CHAIR

OPERATING INSTRUCTIONS

SEAT HEIGHT ADJUSTMENT

TILE TENSION ADJUSTMENT

SEAT SLIDE ADJUSTMENT

BACK ADJUSTMENT

ARMREST ADJUSTMENT

LUMBAR ADJUSTMENT

To operate pull up to allow seat to rise releasing

when you have reached desired height. In order

to lower operator is to be seated in the chair

and lever is pulled up again releasing when

height reached.

Pull the tension adjustment winder out and

rotate it in the “+” direction to increase the

reclining tension. Rotate the winder in the “-”

direction to decrease it. Adjust the tension

according to your physical size and preference.

Press the bottoms inside the armrests to adjust

the height of the armrests, you can also adjust

the horizontal angle of the armrest in the

outward or inward directions.

While seated, bring your both hands to the

rear of the backrest, then with your back

lifted slightly o the backrest, lift or lower the

adjustment levers on both sides.

Pull out the seat slide lever under the right hand

side of the seat, release the lever when the

desired depth is achieved.

To lock back so no recline is available pull lever

up until locked. Push lever down fully to allow

back to free ﬂoat meaning recline is achieved

whenever operator leans back.