User Manual

1. Take circle cutter out of packaging

2. Twist brass screw and slide black bracket towards middle of yellow

arm. Tighten brass screw. (fig. 1, 2)

3. Remove pivot point cover and move to yellow holding area at the

head of the cutter. (fig. 3, 4, 5)

4. Squeeze and lift black blade guard

(fig. 6) to expose the rotary blade.

5. Using only one hand, grasp the black

ratchet wheel handle. (fig. 7)

6. While applying consistent pressure

downward, rotate in a clockwise direction.

The ratchet will click as it turns.

7. Do not hold the circle cutter with two

hands. (fig. 8)

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Instructions – how to cut a circle using the OLFA Circle Cutter

PAGE 1
Instructions – how to cut a circle using the OLFA Circle Cutter 1. Take circle cutter out of packaging 2. Twist brass screw and slide black bracket towards middle of yellow arm. Tighten brass screw. (fig. 1, 2) Fig. 1 Fig. 2 3. Remove pivot point cover and move to yellow holding area at the head of the cutter. (fig. 3, 4, 5) Fig. 3 Fig. 5 Fig. 4 4. Squeeze and lift black blade guard (fig. 6) to expose the rotary blade. Fig. 6 5. Using only one hand, grasp the black ratchet wheel handle. (fig. 7) 6.
PAGE 2
How to change the blade – OLFA Circle Cutter 1. With one hand, grasp the brass pin on the inside of the blade. (fig. 1) 2. With the other hand, slide the black safety lock upwards. (fig. 2, 3) Fig. 2 Fig. 1 Fig. 3 3. Remove brass pin & blade from circle cutter. (fig. 4) 4. Carefully remove old blade, and replace with a new blade on the brass pin. 5. Reinsert brass pin into circle cutter, and slide black safety lock down. Fig. 4 Need More Help? Visit www.olfa.