OMEN-1F-202012

User Manual LR-1F
OMEN-1F-202012
4
NO.
definition
6
RxData-：receive-
7
NC
8
NC
Table 3 Definition of Ethernet interface
Figure 6 Diagram of Ethernet interface
4.3 Communication interface
The LR-1F is connected to the computer by a RJ-45 Ethernet interface. The computer IP
address should be set up before communication. The LiDAR and computer IP must be set up in
the same subnet without any conflict. The host port is 2368 by default.
The factory default settings are as follows
 Computer IP:192.168.1.10
 Computer subnet mask:255.255.255.0
The default factory settings of LiDAR are as follows
 Lidar IP:192.168.1.100
 Lidar subnet mask:255.255.255.0
The operation steps are as follows
Figure 7 Step 1 of computer IP setting
Female:
Male: