Use and Care Manual

STEP 1 Plug into a grounded 120v electrical outlet only. If using an extension
cord, make sure it’s out of the way to prevent tripping.
STEP 2 Push WARM switch on. Push KETTLE switch on and immediately add
oil (1 tbsp per ½ cup kernels), allow to heat for 3-4 minutes. DO NOT HEAT
KETTLE WITHOUT OIL. (Fig. 1)
STEP 3 When oil is heated, open lid [CAUTION: LID IS HOT!] and add up to 3
kernel scoops (1 cup) of popcorn kernels (Fig. 2). Push STIR switch on (Fig.
3). Close the doors carefully. Popcorn should begin popping in 2-3 minutes.
STEP 4 When popping has stopped, push STIR switch off, then KETTLE.
(Fig.3) Do not add seasoning or toppings into kettle.
STEP 5 Rotate the kettle arm to dump popcorn kettle. CAUTION! KETTLE
AND LID ARE HOT! (Fig. 4) Leave the WARM light on to warm the popcorn
until served. Turn all controls off and unplug popper.
Fig. 1 Add Oil
Fig. 2 Add Kernels
Fig. 3 Press STIR
Fig 4. Dump Kettle
Operating instructions