Use and Care Manual

Operating Instructions
Page | 11
Press KETTLE Button Add Oil Add Kernels Dump Kettle
STEP 1: Plug into a grounded 120v electrical outlet only. If using an extension cord, make sure it’s out
of the way to prevent tripping.
STEP 2: Push WARM switch on. Push KETTLE switch on. Lift lid up with the handle and attach to
magnet on the ceiling. Immediately add oil (1 Tbsp per ½ cup kernels), and up to 1‐1/2 kernel
scoops (3/4 cup) of popcorn kernels. Close lid. Allow to heat for 3‐4 minutes. DO NOT HEAT KETTLE
WITHOUT OIL.
STEP 3: Close the glass door carefully. Popcorn should begin popping in 2‐3 minutes.
STEP 4: When popping has stopped, push the KETTLE switch off. (Fig.3). Do not add seasoning or
toppings into kettle.
STEP 5: Gently rotate the roller arm on the kettle to release kettle and dump popcorn. CAUTION!
KETTLE AND LID ARE HOT! Leave the WARM light on to warm the popcorn until served.
STEP 6: Turn all controls off and unplug popper.