Use and Care Manual

Popcorn Cart Assembly
Page | 6
STEP 1:
Screw one of the RUBBER FEET (A) into the bottom of each
SUPPORT LEG (B). Tighten both rubber feet.
STEP 2:
Insert one WHEEL BOLT (O) into the bottom holes
located on each side of the SUPPORT STAND (C). NOTE:
Insert bolt from the inside out. Secure wheel bolts with
one NUT (Q) on each side. Tighten with wrench.
STEP 3:
Hang one WHEEL (D) onto one WHEEL BOLT (O) and
secure with one NYLOC NUT (P). Tighten with wrench.
Repeat step for second wheel. Note: Do not
overtighten. Make sure both wheels spin freely.
STEP 4:
Attach both HORIZONTAL SUPPORTS ‐ BASE (E) to
the same SUPPORT STAND (C) using two BOLTS (T)
each with one WASHER (R). Tighten with wrench.
STEP 5:
Insert two BOLTS (U), each with one WASHER (R),
into each SUPPORT LEG (B). Attach SUPPORT LEG (B)
to the SUPPORT STAND (C) on the opposite side of
the wheels. Tighten with wrench.