Installation Guide

4.
5.
6.
pg. 2
(pic 4)
(pic 5)
(pic 6)
3.
There are six 5 lb. bags of adhesive in your kit. Use
one at a time to avoid loss of material. Place 2 ¼
cups of water in a small bucket and then empty in
one 5 lb. bag of adhesive (pic 3). Take necessary
precautions to avoid spills.
Thoroughly mix using a margin trowel or small mixer
until you have reached a consistency similar to icing.
Let stand for 8 minutes.
(THIS IS CRITICAL. NOT ALLOWING THIS TIME
COULD PRODUCE POOR ADHESION.)
Mix again for 1 minute (pic 4).
Fill grout bag with 3-4 cups of adhesive while
avoiding any necessary air pockets (pic 5). Do not
overfill. Twist open end of bag to close.
Apply adhesive to backs of thin brick by holding the
bag at a 45° angle to the brick. Gently squeeze
and twist the bag at the same time for a consistent
line (pic 6). Apply to 5-10 bricks at a time.
*Note: Rinse bag after use. It will be used later.
(pic 3)
Adhesive Application