Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
86
OKIPOS 425D
|
3 Crimping
a Crimp paper on both right/left sides.
b Apply crimping from the front surface, making no protrusion on the surface.
c All the sheets must be engaged securely with each other at the crimp position free of lifting.
d Use a double-type crimp and apply crimping in the direction to produce the crimped mark horizontal to the paper
right/left edges.
e Press paper after crimping to eliminate lifting.
OP425_23.eps
1
2
3
4
5
6
7
8
9
10
1 50.8 interval
2 Paper inserting direction
3 Horizontal perforated line
4 2 or more
5 Approx. 1
6 Press paper to prevent lifting
7 Form/Position of Crimping
8 Quadruple crimping
9 Enlarged Figure of Crimped Mark
10 Unit: mm