Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
74
OKIPOS 425D
|
2 Counterfoil and Stub
OP425_11.eps
1 Printing area
2 Stub
3 Inserting direction
A25023.doc
Symbol Designation Standard Value
W Paper width 70mm (2.76 inch) or more
L Paper length 40mm (1.57 inch) or more
A Print starting position 18mm (0.7 inch) or less
B Left margin 2.54mm (0.1 inch) or more
C Right margin 2.54mm (0.1 inch)
D Printing area width Max 160.02mm (6.3 inch)
Note 1 To feed paper, insert a paper from the top side of the device and keep holding it until printing ends.
Note 2 Use a flat sheet free curls, bends (especially those on its edges), cambers, wrinkles, etc. If a sheet is not flat, it may
be contaminated with ink due to ink ribbon contact.
Note 3 Before printing on a stub, fold the other sheets backward to make the stub available for print as shown in the fig.
below.
OP425_12.eps
1 Fold backward
2 Stub
1
2
3
1
2