Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 57
Sprocket Paper
When sprocket paper gets jammed, remove the paper, following the procedure shown below.
1. Open the Tractor Cover (1) and cut the sprocket paper at the perforation (2).
o425_57.jpg
2. Press the Cover Open Bar and open the printer cover
o425_31.jpg and o425_32.jpg
3. Slowly pull out the paper upward or toward you while pulling the lever (1) [marked “PULL”] toward you.
Note: Be careful not to leave small pieces of paper behind.
o425_80.jpg
2
1
1