Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
54
OKIPOS 425D
|
3. Press the two levers (1) on either side at the same time as shown, lift the plate assembly and gently pull out the jammed
paper in the direction of the arrow.
Note:Be careful not to leave small pieces of paper.
o425_76.jpg and o425_77.jpg
4. Load a new paper roll.
For the procedure to load Roll Paper, refer to Section 1.5.1.
Note: Before loading Roll Paper, press down on the two levers shown below to close the plate assembly securely.
o425_78.jpg
Auto Cutter
When paper gets jammed at the Auto Cutter, remove the paper following the procedure below.
1. Press the Cover Open Bar, and open the printer cover.
Caution! The printhead may be HOT!
o425_31.jpg and o425_32.jpg
1
1