Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 51
3.2.2 Roll Paper (Journal)
1. Make sure that the media mode is set to one of the following: Receipt mode, journal mode, or Receipt + Journal mode. If
not, set to one of the above modes. For mode switching, refer to Section 2.1.
2. Press Form Feed switch on the Journal side so that the whole Journal Roll Paper is ejected.
o425_72.jpg
1 Journal Paper Form Feed Switch
2 Media Mode Display LED
• Green light on: Journal + Receipt mode
• Green light blinking (slow): Journal mode
• Green light blinking (quick): Receipt mode
3. Press the Cover Open Bar and open the printer cover.
Caution! The printhead may be HOT!
o425_31.jpg and o425_32.jpg
1
2