Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 43
2.6 MICR Read Test (Receipt)
This function performs MICR read and prints that result on the receipt paper.
Effective only when the MICR unit is installed and “MICR Unit = Yes(CMC-7)” or “MICR Unit = Yes(E-13B)” is set in the
menu.
(1) How to start
Turn the power on while holding down SW2 + SW3.
(2) How to exit
Turn the power off.
(3) Contents of the test
(a) When this mode is started, the printer enters Wait for MICR Insertion state.
(b) Insert MICR card and perform MICR read.
(c) The printer prints MICR read results on the Receipt paper, and enters Wait for MICR Insertion state.
(b) and (c) above are repeated.