Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 41
2.5 Using the MICR Reader
If your printer has the factory installed optional MICR (Magnetic Ink Character Recognition) reader that enables the printer to
read and process MICR characters on personal checks, read this section.
Note 1: If Cut-sheet Paper or Sprocket Paper has been loaded, eject it before you use the MICR feature. This does not apply
to the Roll Paper.
Note 2: When the Tractor (Option) (1) has been installed, remove or park the Sprocket Paper, then switch the Lever to the
Cut Sheet side (1) from the Sprocket side (3)
o425_50.jpg
Note 3: When using a MICR-version machine, align the marks “¶” and “Ä” as shown and set the paper along the paper
guide.
Note 4: Use a flat Check Sheet. If you use Check Sheets that are dog-eared, have wrinkles, or are wavy, they are more likely
to cause a paper jam, scan failure, or damage to the MICR Head.
o425_59.jpg
1 Sheet Guide
2
1
3
1