Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 29
3. Set the tractor lever (1) in the direction of the arrow.
o425_18.jpg
4. Turn on the printer.
5. Pull up on the lock levers (1) and open the tractor covers (2), then move the right tractor over to fit the width of the paper.
Center the support (3) between the tractors.
o425_50.jpg
6. Place the first two holes in the paper over the tractor pins (4) on either side and close the tractor covers.
o425_51.jpg
1
1
4
2
1
3
4
2