Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 25
1.5.3 Cut-Sheet Paper (Validation/Stub)
1.5.3.1 Loading the Cut-Sheet Paper (Validation/Stub)
Use the paper that matches the specifications.
Note: The printer must be turned on before loading the paper.
1. Turn on the printer.
2. With the right edge of the paper positioned at the “Ä” mark on the Cover Top, insert the paper.
o425_48.jpg
Note: To feed paper along the long edge, remove the Piece (1) on the left side of the printer cover and set the paper.
o425_72.jpg
1