Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 137
The application judges that the top 1 inch of “Top Margin 2 inches” is the printer’s mechanical Auto Loading position,
therefore the application does not produce data for the actual data transfer. Thus, the application produces data while ignoring
the data in the first 1 inch from the top of that data. Unless you set the printer Auto Loading to 1 inch, you cannot get the
printing result you expect.
This function is valid with printers that support Auto Loading. Although this printer does not support Auto Loading, the
printer menu setting has “Top Adjust.” Thus, you can access this function by changing this menu setting.
Normally, you need not change, but use this function as needed.