Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
128
OKIPOS 425D
|
4 With the Paper Guide pushed to the right, insert 101.6 mm (4.0")-wide paper to print.
o425_119.jpg
1 Target Printing Area
2 Printable Maximum Width 160.02mm (6.3 inch)
3 Slip Tray Left Side
4 Slip Tray Right Side
5 Paper Guide
6 Right Margin 27.94mm (1.1 inch) or more
5 When you need to print Custom Size paper (e.g. 101.6 mm (4.0") in its full width, follow the procedure below.
a Set the length of the paper in the Custom Size Setup dialog. (The width is fixed at 187.96 mm [7.4"].)
b Open an application you want to use and customize your paper at Custom Size on the Page Setup menu.
Set the margins you want within the specified range at Margins on the Page Setup menu.
Example
The left margin that is actually set up for using 101.6 mm (4.0") paper can be calculated according to the following formula.
[Width of Custom Paper Size fixed] - [Width of paper size actually used] - [Printing disabled area] + [Left margin for
paper used]
187.96 mm (7.4") - 101.6 mm (4.0") - 25.4 mm (1.0") + 2.54 mm (0.1") or more
Set the right margin at 27.94 mm (1.1") (Printing disabled area 25.4 mm [1.0"] + minimum right margin 2.54 mm [0.1"]) or
more.