Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 127
Set the right margin at 27.94 mm (1.1") (Printing disabled area 25.4 mm [1.0"] + Slip paper’s minimum right margin 2.54 mm
[0.1"]) or more.
Image of actual printing area
O425_112.jpg
1 Target Printing Area
2 Printing Area with margin adjusted
3 Left margin for paper to be used 2.54mm (0.1 inch) or more
4 Width of Paper Size actually used 101.6mm (4.0 inch)
5 Right margin for paper to be used 25.4mm (1.1 inch) or more (including the printing disabled area)
6 Right margin actually set
7 Paper Size 187.96mm (7.4 inch)
8 Left margin actually set