Printer Developer's Guide
Table Of Contents
- Contents
- 1. Setting Up the Printer
- 1.1. Select a Location
- 1.2 Where to install your printer
- 1.3 Unpacking
- 1.4 Installing the Printer
- 1.5 Installing the Paper
- 2. Using the Printer
- 3. Maintenance
- 4. Troubleshooting and Repair
- 5. Specifications
- 5.1 Introduction
- 5.2 General Specifications
- 5.3 Communication Interface Specifications
- 5.4 Physical Characteristics
- 5.5 Logical Characteristics
- 5.6 Printer Performance
- 5.7 Media Specifications
- 5.8 Paper Feed Specifications
- 5.9 MICR Specifications (Only with MICR type)
- 5.10 Auto Cutter Specifications
- 5.11 Ribbon Specifications
- 5.12 Reliability
- 6. Command Description
- 7. Using the Unitool Printer Driver
- 1. Setting Up the Printer
|
Developer’s Guide: English 101
6.1.2.3 FS Sequence
1 Command recognition
FS codes in combination are handled the same way that DLE codes are handled.
2 FS Sequence table
A25042.doc
No. HEX Command Sequence Functions Print
Start
1 1C 61 30 FS a 0 n Reads Check paper X
2 1C 61 31 FS a 1 Loads Check paper to the print start position X
3 1C 61 32 FS a 2 Ejects Check paper X
4 1C 62 FS b Requests for resending a result of reading
Check paper
X
6.1.2.4 GS Sequence
1 Command recognition
GS codes are handled the same way that DLE codes are handled.
2 GS Sequence table
A25043.doc
No. HEX Command Sequence Functions Print
Start
1 1D 05 GS ENQ Sends a status of the printer status real-time X
2 1D 45 GS E n Selects print speed and printhead current
flow time
X
3 1D 49 GS I n Sends a printer ID X
4 1D 61 GS a n Enables/disables auto status send X
5 1D 72 GS r n Sends a status X