Quick Start Manual

- 87 -
Scanning to Local PC
4
Scanning
Connecting using wireless LAN (MB451w,
MB471w only):
Use the WPS (push button) function to set the
wireless LAN. For details on other methods for
setting the wireless LAN, refer to the User’s
Manual (Basic), “Network Connection”.
1 Log in as the administrator.
2 Press the to select [Network Menu],
and then press the .
3 Press the to select [Network Setup],
and then press the .
4 Press the to select [Wireless
Setting], and then press the .
5 Press the to select [Set
automatically (WPS)], and then press
the .
6 Press the to select [WPS-PBC], and
then press
OK
.
7 Press the to select [Yes], and then
press
OK
.
Memo
● Start the WPS push button for wireless AP
after clicking [Yes] in the conrmation screen.
Alternatively, if WPS push button for wireless AP
is started rst, start the WPS push button on this
equipment.
● If [No] is selected, the screen returns to that from
step 6.
8 If [Yes] is selected in step 7, [Running
pushbutton method...] is displayed in
the screen.
Note
● Panel operations cannot be performed during WPS
execution.
● When [Connection successful] is displayed, this
equipment is connected to the wireless LAN.
Memo
● If [Timeout] is displayed, it is possible that the
wireless AP of the connection destination could not
be found within the time limit. Select [Yes] again in
step 7 within 2 minutes of starting WPS push button
for wireless AP.
● If [Overlap] is displayed, WPS-push button is being
executed on 2 or more wireless AP. Please wait for a
short time and then retry.