Quick Start Manual

- 80 -
Scanning to Local PC
4
Scanning
6 Press the to select [WPS-PBC], and
then press
OK
.
7 Press the to select [Yes], and then
press
OK
.
Memo
● Start the WPS push button for wireless AP
after clicking [Yes] in the conrmation screen.
Alternatively, if WPS push button for wireless AP
is started rst, start the WPS push button on this
equipment.
● If [No] is selected, the screen returns to that from
step 6.
8 If [Yes] is selected in step 7, [Running
pushbutton method...] is displayed in
the screen.
Note
● Panel operations cannot be performed during WPS
execution.
● When [Connection successful] is displayed, this
equipment is connected to the wireless LAN.
Memo
● If [Timeout] is displayed, it is possible that the
wireless AP of the connection destination could not
be found within the time limit. Select [Yes] again in
step 7 within 2 minutes of starting WPS push button
for wireless AP.
● If [Overlap] is displayed, WPS-push button is being
executed on 2 or more wireless AP. Please wait for a
short time and then retry.
Setting the IP address:
1 Press the <SETTING> key on the
operator panel.
2 Press the to select [Easy Setup], and
press
OK
.
3 Enter the administrator password.
The factory default password is “aaaaaa”.
a Press , , , to select the
character you want, and then
press
OK
.
- The selected character is entered as “*” in
the text eld.
- If you have entered an incorrect value,
press the <CLEAR> key and then enter
the correct value.