Quick Start Manual

- 76 -
Scanning to Network PC
4
Scanning
Procedure for Scan to Network
PC
This section explains how to start Scan to
Network PC.
You need to congure the initial settings before
using the Scan to Network PC function.
Memo
● The following procedure uses the factory default settings.
1 Press the <SCAN> key on the operator
panel.
2 Place your document in the ADF or on
the document glass as below:
● ADF
Load documents face up with the top edge of the
documents in rst.
Adjust the document guides to the width of your
documents.
● Document Glass
Place the document face down and align its top
edge to the upper-left corner of the glass.
Close the document glass cover gently.
Note
● Do not apply an excessive load to the document
glass.
Memo
● The machine prioritizes the ADF when scanning
documents. Be sure not to place documents on the
ADF when you use the document glass.
3 Press the to select [Network PC] and
then press
OK
.
4 Check that [Select Prole] is selected
and then press
OK
.
5 Press the to select a prole and then
press
OK
.
6 Press
MONO
or
COLOR
.
Reference
● To load a landscape document, refer to the User’s Manual
(Basic) > “1. Setup” > “Loading Paper and Documents” >
“Documents” > “Loading Documents”.
● You can change the scan settings such as scan size
and resolution as necessary. For details, refer to the
User’s Manual (Advanced) > “3. Scanning” > “Advanced
Operations for Scanning, Internet Faxing and Scanning to
Fax Server”.