Quick Start Manual

- 53 -
Scanning to E-mail
4
Scanning
 Connecting using wireless LAN
(MB451w, MB471w only)
Use the WPS (push button) function to set the
wireless LAN. For details on other methods for
setting the wireless LAN, refer to the User’s
Manual (Basic), “Network Connection”.
1 Log in as the administrator.
2 Press the to select [Network Menu],
and then press the .
3 Press the to select [Network Setup],
and then press the .
4 Press the to select [Wireless
Setting], and then press the .
5 Press the to select [Set
automatically (WPS)], and then press
the .
6 Press the to select [WPS-PBC], and
then press
OK
.
7 Press the to select [Yes], and then
press
OK
.
Memo
● Start the WPS push button for wireless AP
after clicking [Yes] in the conrmation screen.
Alternatively, if WPS push button for wireless AP
is started rst, start the WPS push button on this
equipment.
● If [No] is selected, the screen returns to that from
step 6.
8 If [Yes] is selected in step 7, [Running
pushbutton method...] is displayed in
the screen.
Note
● Panel operations cannot be performed during WPS
execution.
● When [Connection successful] is displayed, this
equipment is connected to the wireless LAN.
Memo
● If [Timeout] is displayed, it is possible that the
wireless AP of the connection destination could not
be found within the time limit. Select [Yes] again in
step 7 within 2 minutes of starting WPS push button
for wireless AP.
● If [Overlap] is displayed, WPS-push button is being
executed on 2 or more wireless AP. Please wait for a
short time and then retry.