Printer User Manual

VI - 3
Section 6 - Chapter 1 - Introduction
OKI OkiLAN 6020e User’s Guide
EtherTalk
Chapter 1
Introduction
Overview
This section describes the steps necessary to configure
the EtherTalk protocol. The following topics are
covered in this section:
• Setting the Printer Name
• Selecting a Zone
• Selecting the Printer from the Macintosh Chooser
• Print Configuration and Status Information
• Advanced Configuration
System Requirements
Please note the following system requirements:
• PostScript Level 2 must be available on your printer
• The network must be a Phase 2 EtherTalk network
• Your printer must have a bidirectional parallel port
(IEEE-1284 standard)
Ethertalk is only available on the parallel port..
Before You Start
1. Install the OkiLAN 6020e hardware and connect the
cabling. Instructions for hardware installation are
found in Section I of this manual.
2. Write down the serial number and Ethernet address
of the OkiLAN 6020e.
3. Copy the files from the CD-ROM to a utilities folder
on the Macintosh hard drive.
4. Consult your network administrator before using the
OkiLAN 6020e utility. Changing the OkiLAN 6020e
Name or Zone may require users to reselect the
OkiLAN 6020e in the Chooser. Print servers and
spoolers may also need to be reconfigured after the
OkiLAN 6020e product’s configuration has been
changed.