Hard Disk Drive (HDD) Installation Instructions 59375102
© 2007 by Oki Data Americas, Inc. All rights reserved. Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. The manufacturer assumes no responsibility for the results of errors beyond its control. The manufacturer also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability of the information in it.
Prepare the Printer 1. Turn off the printer. 2. Detach the power cord from the back of the printer. 3. Detach the interface cable from the back of the printer. 4. Remove and save the thumbscrews at the top and bottom which hold the control board cover in place.
5. Open the control board cover by pulling out and to the left.
Install the Hard Disk Drive (HDD) 1.
2. Remove the hard disk drive from its shipping package. Caution! Observe antistatic precautions when installing the hard disk drive. 3. Lift the handle on the HDD and insert the connector firmly into the socket on the control board.
4. Press down on the handle to lock it in place.
Complete the Installation 1. Close the control board cover and reinstall the screws at the top and bottom. 2. Reattach the interface cable, then the power cord. 3. Turn on the printer.
Verify the Installation Print the Configuration Report 1. Press Enter to access the printer menu. 2. Press Enter to select Configuration. 3. Press the ∇ key. 4. Press Enter to select Print Information. 5. Press Enter to select Execute. The Configuration report prints. 6. In the listing under Configuration, System, “HDD: installed” should appear. If you see “HDD: uninstalled”, repeat the installation steps—checking to be sure that the Hard Disk Drive is firmly seated in the printer connector—until it does.
Activate the HDD in the Driver Windows® Postscript Emulation Driver 1. First Windows Vista a. Click Start → Settings → Hardware and Sound → Printer. The Printer dialog box opens. Windows XP, Server 2003 a. Click Start → Settings → Printers and Faxes. The Printers and Faxes dialog box opens. Windows 2000 a. Click Start → Settings → Printers. The Printers dialog box opens. 2. Right click the appropriate printer icon. Click Properties. 3. Click the Device Settings tab. 4. Scroll down to Installable Options.
5. Select Installed. 6. Click OK and close the dialog box. PCL Driver 1. First Windows Vista a. Click Start → Settings → Hardware and Sound → Printer. The Printer dialog box opens. Windows XP, Server 2003 a. Click Start → Settings → Printers and Faxes. The Printers and Faxes dialog box opens. Windows 2000 a. Click Start → Settings → Printers. The Printers dialog box opens. 2. Right click the PCL printer icon. Click Properties. 3. Click the Device Option(s) tab. 4. Click Printer Hard Disk. 5.
Macintosh® Mac OS 10.2, 10.3, 10.4 1. First OS 10.2 a. Activate Print Center: Local Hard Drive → Applications → Utilities → Print Center. OS 10.3, 10.4 a. Activate the Printer Setup Utility: Local Hard Drive → Applications → Utilities → Printer Setup Utility. 2. Highlight the printer name. Select from the menu Printers → Show Info. 3. Click the Name & Location drop-down menu at the top of the screen and select Installable Options. 4. Click the box next to Hard Disk to enable the option. 5.
